Table of Contents
Advertisement
102 Maintenance Releases
Installing the firmware upgrades
Use these procedures to install firmware upgrades.
Installing the firmware updates navigation
•
•
•
•
•
•
•
Installing BIOS firmware upgrades
Use this procedure to install upgrades to the BIOS firmware. This
procedure requires the reboot of the server.
Prerequisites
•
•
Procedure Steps
Step
1
2
3
4
Copyright © 2007-2008 Nortel Networks
.
If the versions do not match, upgrade the firmware.
"Installing BIOS firmware upgrades" (page 102)
"Installing Base Management Controller (BMC) firmware upgrades"
(page 103)
"Installing diagnostics firmware upgrades" (page 104)
"Installing RSA-II card firmware upgrades" (page 105)
"Installing NIC firmware upgrades" (page 106)
"Installing hard drive firmware upgrades" (page 106)
"Installing ServeRAID firmware upgrades" (page 107)
You must be assigned to the SSA role (ntsysadm).
You must have the CD containing the BIOS firmware upgrade file.
Action
Load the BIOS firmware upgrade CD into the CD-ROM drive.
Log on to the server as the SSA role (ntsysadm).
Reboot the server.
sudo reboot
If the operating system has been installed, change the boot
sequence so that the CD-ROM is the primary boot device by
doing the following:
•
When the BIOS information appears, press F12 to select the
boot sequence.
•
Select CD-ROM as the primary boot device.
Otherwise, wait for the server to reboot.
Application Server 5300
Nortel AS 5300 Installation
NN42040-300 01.04
4 November 2008
--End--
Advertisement
Table of Contents
