Table of Contents
Advertisement
104 Maintenance Releases
5
6
Installing diagnostics firmware upgrades
Use this procedure to upgrade the diagnostics firmware. This procedure
requires the reboot of the server.
Prerequisites
•
•
Procedure Steps
Step
1
2
3
4
Copyright © 2007-2008 Nortel Networks
.
If the firmware is out of date, the system flashes the firmware.
When the upgrade completes, remove the CD from the CD-ROM
drive.
Use the ASM Remote Control to restart the server and boot to
the operating system:
Server > Tasks > Server Restart
You must be assigned to the SSA role (ntsysadm).
You must have the CD containing the diagnostics firmware upgrade
file.
Action
Load the diagnostics firmware upgrade CD into the CD-ROM
drive.
Log on to the server as the SSA role (ntsysadm).
Reboot the server.
sudo reboot
If the operating system has been installed, change the boot
sequence so that the CD-ROM is the primary boot device by
doing the following:
•
When the BIOS information appears, press F12 to select the
boot sequence.
•
Select CD-ROM as the primary boot device.
Otherwise, wait for the server to reboot.
The IBM Flash Update Utility automatically flashes the firmware
and reboots the system when it completes.
Attention: It may take up to 5 minutes for the firmware to be
flashed. Do not power off or restart system.
Application Server 5300
Nortel AS 5300 Installation
NN42040-300 01.04
4 November 2008
--End--
Advertisement
Table of Contents
