Pitney Bowes DP50S Operating Instructions Manual page 179

Message
sap enable, saptype=<SAP type>,
sapname=<SAPname>
session_IPv4 <community name> not defined.
session_IPv6 <community name> not defined.
session_ipx <community name> not defined.
Set context to <NDS context name>
shutdown signal received. network servicere-
booting...
Smbd start. (NetBIOS)
SMTPC: failed to connect smtp server.
SMTPC: failed to connect smtp server. timeout.
Problem and solutions
The SAP function has started. The SAP packet
isissued to advertise the service on the SAP
table onthe NetWare server.
The requested community name is not defined.
The requested community name is not defined.
The requested community name is not defined.
An NDS context name has been set.
The smbd service has started.
SMBD (ServerMessageBlockDaemon) has
beenstarted.
Connection to the SMTP server failed. This
could bebecause no connection to the network
has beenestablished, or the network configura-
tion isincorrect, so there is no response from
the SMTPserver, or the specified SMTP server
name isincorrect, or the specified SMTP server
IP addresscould not be found in the DNS server,
or a serverother than the SMTP server has been
specified, orthe specified SMTP server port
number is incorrect.
Check the DNS Server's IP address and
SMTPserver's IP address, or the SMTP server
name and
SMTP port number, or the SMTP server's SMTP
portnumber, or the network connection andcon-
figuration.
Connection to the SMTP server failed due
totimeout. This could be because the specified
SMTPserver name is incorrect, or no connec-
tion to thenetwork has been established, or the
networkconfiguration is incorrect, so there is
no responsefrom the SMTP server. Check the
SMTP servername, or the network connection
andconfiguration.
Message List
4
181