Pitney Bowes DP50S Operating Instructions Manual page 175

Message
add_sess_IPv6: community <community
name>already defined.
add_sess_IPX: bad trap
addr:<IPXaddress>community <community
name>
add_sess_IPX: community <community
name>already defined.
adjust time server <NTP server> offset:XX sec.
Attach FileServer =<file server>
Attach to print queue <print queue name>
btd is disabled.
centrod is disabled.
child process exec error! (process name)
Connected DHCPv 6 server (IPv 6 address)
connection from <IP address>
Could not attach to FileServer <error number>
Problem and solutions
The same community name already exists. Use-
another community name.
The IPX address (00:00:00:00:00:00) isunavail-
able when the community access type is
TRAP. Specify the host IPX address for the
TRAPdestination.
The same community name already exists. Use-
another community name.
ncsd tells you the timing of the NTP server and-
whether or not the time system clock is set.
Connection to the file server as the nearest
serverhas been established.
(In the print server mode) Attached to the print-
queue.
Communication via Bluetooth is unavailablebe-
cause btd is disabled in the security mode.
Enable the btd in the security mode.
Communication via parallel connectionsunavail-
able because centrod is disabled in thesecurity
mode.
Enable centrod in the security mode.
The network service failed to start. Turn the print-
eroff and then on. If this does not work, contact
yourservice or sales representative.
The IP address was successfully received from
the
DHCPv 6 server.
A user logged in from the host <IP address>.
(In the remote printer mode) Connection to the
fileserver has not been established. The file
server hasrefused the connection. Check the file
serverconfiguration.
Message List
4
177