Pitney Bowes DP50S Operating Instructions Manual page 176

4. Monitoring and Configuring the Printer
Could not attach to PServer <printer server
name>
Current Interface Speed: <EhternetI/F speed>
Current IPX address <IPX address>
DHCPv6 server not found.
Duplicate IP=<IP address>(from<MAC ad-
dress>).
4
Established SPX Connection with PServer ,
(RPSocket=<socket
number>,connID=<connection ID>)
Exit pserver
Frametype=<frame type name>
IEEE 802.11 <communication mode> mode
IEEE 802.11 Card does NOT support WPA .
IEEE 802.11 Card Firmware REV.<version>
IEEE 802.11 current channel <channel number>
IEEE 802.11 MAC Address = <MAC address>
178
Message Problem and solutions
(In the remote printer mode) Connection to the
printserver has not been established. The print
serverhas refused the connection. Check the
print serverconfiguration.
Speed of the Ehternet interface (10Mbps, 100
Mbps, or 1Gbps).
Current IPX address
The DHCPv6 server was not found. Make sure
thatthe DHCPv6 is on the network.
The same IP address (IPv4, or IPv6 address)
wasused. Each IP address (IPv4, or IPv6 ad-
dress) mustbe unique. Check the address of the
deviceindicated in <MAC address>.
(In the remote printer mode) Connection to the
printserver has been established.
(In the print server mode) The print server
functionis disabled because the necessary print
serversettings have not been made.
The frame type name is configured to be used on
NetWare.
Displays Wireless LAN communication mode
(infrastructure, or 802.11 ad hoc).
A wireless card that does not support WPA isin-
stalled. Install a wireless card that supports WPA.
Displays the version number of the 802.11
card'sfirmware.
Displays the current channel number of the
activewireless card (in ad hoc and infrastructure
mode).
Displays the MAC address of the wireless inter-
face.