Pitney Bowes DP50S Operating Instructions Manual page 166

4. Monitoring and Configuring the Printer
key "key value" val {1|2|3|4}
4
keyphrase "phrase" val {1|2|3|4}
encval {1|2|3|4}
168
Parameter Value configured
You can specify the WEP key when entering
inhexadecimal.
With a 64-bit WEP, you can use 10 digithexa-
decimals. With a 128-bit WEP, you can use
26 digit hexadecimals.
Up to four WEP keys can be registered. Speci-
fythe number to be registered with "val".
When a WEP is specified by key, the WEP-
specified by key phrase is overwritten.
To use this function, set the same key number
and
WEP key for all ports that transmit data to
eachother. Put "0x" on the front of WEP key.
You can omit the numbers with "val". The
keynumber is set to 1 when making these
omissions.
The default is blank.
You can specify the WEP key when entering in
ASCII.
With a 64-bit WEP, you can use 10 digithexa-
decimals. With a 128-bit WEP, you can use
26 digit hexadecimals.
Up to four WEP keys can be registered. Speci-
fythe number to be registered with "val".
When a WEP is specified by key phrase, the
WEP specified by key is overwritten.
To use this function, set the same key number
and
WEP key for all ports that transmit data to
each
other.
You can omit the numbers with "val". The
keynumber is set to 1 when making these
omissions.
You can specify which of the four WEP keys
isused for packet encoding. "1" is set if a num-
beris not specified.