6. COMPUTER OPERATION
PARAMETERS
Odometer (if applicable), Time, Speed, Distance and Calories. All workout parameters may be selected by
the select key.
FUNCTION
POWER ON: Pushing the button on the display will turn the display on and display the parameters of the
previous workout.
SCAN: when the symbol "►" points to SCAN, The monitor will display the functions listed below. Each
function will remain on the screen for 4 seconds. The following modes will automatically cycle through
respectively: TIME –SPEED-DISTANCE-CALORIES-PULSE
TIME: when the symbol "►" points to TMR. The monitor will display total workout time.
SPEED: when the symbol "►"points to SPD, The monitor will display the current speed in km/h.
DISTANCE: when the symbol "►" points to DIST. The monitor will display the total workout distance in km.
CALORIES: when the symbol ""◄" points to CAL. The monitor will display the total workout caloric
consumption in K CAL.
Reset: Hold the button down for more than 3 seconds and all functions will reset to 0.
SLEEP: The display will automatically enter sleep mode if it does not receive a signal after 4 minutes of
inactivity.
SPECIFICATIONS
Auto Scan
Every 4 seconds
Elapsed Time
00:00~99:59
FUNCTION
Speed
0.0~99.9km/h
Distance
0.00~99.99km
Calorie
0.00~999.9kcal
Controller
4 bit single chip microprocessor
Sensor
No-contace magnetic type
Battery type
2 pcs of Size-AA or UM-3
Operating temperature
0°~+40℃
Storage temperature
-10°~+60℃
13
SP-310