Pf Motor - Epson L1800 Service Manual

L1800

3.5.2 PF Motor

1. Remove the Printer Mechanism.
Mechanism (p.61).)
2. Disconnect the PF Motor connector cable from connector CN116 (black) on the
Main Board, and remove it from the Clamp on the Main Frame.
3. Remove the two C.C. M3 x 4 screws that secure the PF Motor.
4. Remove the PF Drive Belt from the PF Motor Pinion Gear, and remove the PF
Motor from the Printer Mechanism.
PF Motor connector cable
PF Motor
CN116
Figure 3-145. Removing the PF Motor
Disassembly And Assembly
(Refer to 3.4.4 Lower Housing / Printer
Clamp PF Drive Belt
1
2
11) C.C. M3x4
(4±0.5 kgf.cm)
Pinion Gear
 Make the slit on the PF Motor face the direction shown in the
A D J U S T M E N T
R E Q U I R E D
figure below.

Tighten the screws in the order shown in
After replacing or removing the PF Motor, always make the required
A D J U S T M E N T
R E Q U I R E D
adjustments referring to the following.
 "Chapter 4
Removing the Motors
Slit
Figure 3-146. Reinstalling the PF Motor
Figure 3-145
Adjustment (p.109)"
Revision A
95
Confidential