Network Scan - ZyXEL Communications LTE3311 series User Manual

Table 14 Network > WAN > Management WAN Edit (continued)
LABEL
Check Timeout
Latency Threshold
Fail Threshold
Target1/Target2
LTE Band
Bridge
IGMP
IGMP Proxy
IP Type
Apply
Cancel
More

6.5 Network Scan

Use this screen to set how you want the LTE3311 to connect to an available mobile network. Click
Network > WAN > Network Scan from the Configuration menu.
Chapter 6 WAN
DESCRIPTION
Type the number of seconds (0 to 99999) for your LTE3311 to wait for a response to
the ping or DNS query before considering the check to have failed. This setting must
be less than the Check Interval. Use a higher value in this field if your network is
busy or congested.
Type a number of milliseconds (0 to 99999) for the latency threshold.
If the specified latency threshold is exceeded, the LTE3311 considers the check to
have failed and makes a new connection after (Latency Threshold * Fail Threshold)
seconds.
Type how many WAN connection checks can fail (0 to 99999) before the connection is
considered "down" (not connected). The LTE3311 still checks a "down" connection to
detect if it reconnects.
Select DNS1 to have the LTE3311 send a DNS query to the first DNS server address
assigned by the service provider.
Select DNS2 to have the LTE3311 send a DNS query to the second DNS server
address assigned by the service provider.
Select Other Host and enter a domain name or IP address of a reliable nearby
computer to have the LTE3311 ping that address.
Select the LTE band on which you want the LTE3311 to be. Select Auto if you want
the LTE3311 to switch to a supported band automatically.
Select this option to allow the computer connected to the first Ethernet LAN port to
get an individual IP address from the ISP's DHCP server directly.
Select IGMP v1, IGMP v2, IGMP v3 or Auto to enable multicasting. This applies to
traffic routed from the WAN to the LAN.
Select Disable to turn off this feature. This may cause incoming traffic to be dropped
or sent to all connected network devices.
This field is available only when IGMP is enabled.
Select this option to have the LTE3311 act as an IGMP proxy on this connection. This
allows the LTE3311 to get subscribing information and maintain a joined member list
for each multicast group. It can reduce multicast traffic significantly.
Select IPv4 if you want the LTE3311 to run IPv4 only.
Select IPv4/IPv6 to allow the LTE3311 to run IPv4 and IPv6 at the same time.
Select IPv6 if you want the LTE3311 to run IPv6 only.
Click Apply to save your changes back to the LTE3311.
Click Cancel to reload the previous configuration for this screen.
Click More to display advanced fields.
LTE3311 Series User's Guide
60