Call Feature Speed Dial Digits - ZyXEL Communications LTE3311 series User Manual

The following table describes the labels in this screen.
Table 55 Application > Voice over IP > Phone Conf.
LABEL
Call Forward Type
URL
DND
Caller ID
Call Waiting
FXS Flash
Signal Detection
Max. Time
FXS Flash
Signal Detection
Min. Time
Hot Line
Hot Line
Number
Waiting Time
before Starting
Hot Line
Apply
Cancel
Call Feature Speed
Dial Digits

17.6.1 Call Feature Speed Dial Digits

Use this screen to view and change the key combinations you can enter on your phone's keypad to
use certain features. To access this screen, click Application > Voice over IP > Phone Conf. and
then click the Call Feature Speed Dial Digits button.
Chapter 17 Voice over IP
DESCRIPTION
Select Disable if you do not want the LTE3311 to forward any incoming calls.
Select Always if you want the LTE3311 to forward all incoming calls to the specified
phone number.
Select Busy if you want the LTE3311 to forward incoming calls to the specified phone
number if the phone port is busy.
Select No Answer if you want the LTE3311 to forward incoming calls to the specified
phone number if the call is unanswered.
Specify the phone number to which the LTE3311 forwards an incoming call.
Select Enable to set your phone to not ring when someone calls you.
Select Caller ID after 1st ring (FSK) or Caller ID after 1st ring (FSK-JP) if you
want to send identification when you make VoIP phone calls. Select Don't show Caller
ID if you do not want to send identification.
Select Enable to place a call on hold while you answer another incoming call on the
same telephone number.
Enter the maximum time (in milliseconds) to detect a hook flash signal from the
connected analog phone. This specifies the time that the LTE3311 waits before rejecting
the second call if you do not answer it.
If the flash signal is longer than the maximum time, the LTE3311 rejects the second
call.
Enter the minimum time (in milliseconds) to detect a hook flash signal from the
connected analog phone.
This specifies the time that the LTE3311 waits before rejecting the second call if you do
not answer it. If the flash signal is shorter than the minimum time, the LTE3311 rejects
the second call.
Select Enable to have the LTE3311 dial the specified hot line number after you pick up
the telephone and do not press any keys on the keypad for a period of time.
Enter the number of the hot line that you want the LTE3311 to dial.
Enter a number of seconds that the LTE3311 waits before dialing the hot line number if
you pick up the telephone and do not press any keys on the keypad.
Click this to save your changes and to apply them to the LTE3311.
Click this to set every field in this screen to its last-saved value.
Click this to open a screen where you can show and configure shows the key
combinations you can enter on your phone's keypad to use certain features. See
17.6.1 on page 122.
LTE3311 Series User's Guide
122
Section