ZyXEL Communications LTE3311 series User Manual page 153

Figure 99 Bandwidth Management Rule Configuration: Application List
The following table describes the labels in this screen.
Table 72 Bandwidth Management Rule Configuration: Application List
LABEL DESCRIPTION
Rule Select Enable to turn on the bandwidth management rule. Otherwise, select Disable.
IP Address Enter the IP address or a range of IP addresses of the destination computer for whom
this rule applies.
Service Select Service Port and manually enter the port number(s) that defines the traffic type,
for example TCP port 80 defines web traffic.
Select Pre-defined Application profiles to configure a bandwidth management rule
for a pre-defined service or application.
Protocol If you set Service to Service Port, select the protocol (TCP, or UDP) used for the
service.
Service Type If you set Service to Pre-defined Application profiles, select the name of the service
to which the LTE3311 applies the bandwidth management rule.
Control Select Maximum Bandwidth or Minimum Bandwidth and specify the maximum or
minimum bandwidth allowed for the rule in KBps (kilobytes per second) or MBps
(megabytes per second).
Otherwise, select Priority and enter a priority level (from 1 to 7) for traffic that matches
this rule.
Direction Select To LAN&WLAN to apply the rule to traffic from WAN to LAN and WLAN.
Select To WAN to apply the rule to traffic from LAN/WLAN to WAN.
Select Both to apply the rule to traffic traveling in either direction.
Sharing Method This field is available only when you set Control to Maximum Bandwidth or Minimum
Bandwidth.
Select Grouping to have all IP addresses in the rule share the specified bandwidth.
Select Single and each IP address in the rule can have the specified bandwidth.
Apply Click Apply to save your customized settings.
Cancel Click Cancel to exit this screen without saving.
See Appendix D on page 216
Chapter 21 Bandwidth Management
for commonly used services and port numbers.
LTE3311 Series User's Guide
153