ZyXEL Communications LTE3311 series User Manual page 59

Table 14 Network > WAN > Management WAN Edit (continued)
LABEL DESCRIPTION
Country Select the country in which you use the LTE3311.
Service Provider Select the name of your service provider. The options vary depending on the country
you selected.
If your service provider is not in the list, select Others.
APN Connections with different APNs (Access Point Names) may provide different services
(such as Internet access or MMS (Multi-Media Messaging Service)) and charge
method.
The corresponding APN automatically displays when you select a pre-defined service
provider.
If you select Others in the Service Provider field, manually enter the APN provided
by your service provider. You can enter up to 32 ASCII printable characters. Spaces
are allowed.
Dialed Number This is the phone number (dial string) used to dial up a connection to your service
provider's base station. Your service provider should provide the phone number. For
example, *99# is the dial string to establish a GPRS or 3G/4G connection in Taiwan.
The corresponding phone number automatically displays when you select a pre-
defined service provider.
If you select Others in the Service Provider field, manually enter the phone
number provided by your service provider.
Account Type the user name (of up to 64 ASCII printable characters) given to you by your
service provider.
Password Type the password (of up to 64 ASCII printable characters) associated with the user
name above.
Authentication The LTE3311 supports PAP (Password Authentication Protocol) and CHAP (Challenge
Handshake Authentication Protocol). CHAP is more secure than PAP; however, PAP is
readily available on more platforms
Select an authentication protocol (PAP, or CHAP) used by the service provider.
Otherwise, select Auto to have the LTE3311 accept either CHAP or PAP.
Primary DNS Enter the first DNS server address assigned by the service provider.
Secondary DNS Enter the second DNS server address assigned by the service provider.
Roaming 3G/4G roaming is to use your mobile device in an area which is not covered by your
service provider. Enable roaming to ensure that your LTE3311 is kept connected to
the Internet when you are traveling outside the geographical coverage area of the
network to which you are registered.
Connection Control Select Auto Reconnect (always-on) if you do not want the connection to time out.
Select Connect-on-Demand if you do not want the connection up all the time and
specify an idle time-out in the Maximum Idle Time field.
Maximum Idle Time Specify the time in minutes that elapses before the LTE3311 automatically
disconnects from the service provider.
MTU Enter the MTU (Maximum Transmission Unit) of each data packet, in bytes, that can
move through the WAN connection.
Network Monitoring Select Enable to have the LTE3311 test the WAN connection by periodically sending
DNS Query to a DNS server or sending a ping (ICMP Checking) to either the
default gateway or the addresses you specify in the Target1 and Target2 fields.
Loading Check Select this option to check how many packets have been transmitted or received
through the WAN connection within a time period specified in the Check Interval
field.
Check Interval Type a number of seconds (0 to 99999) to set the time interval between checks.
Allow more time if your destination IP address handles lots of traffic.
Chapter 6 WAN
LTE3311 Series User's Guide
59