Table of Contents
Advertisement
TIA/EIA Standard 568B (Gold Pins Facing Up)
Pin 1
Pin 2
Pin 3
Pin 4
6.12. Installation Instructions
1. Install the Category cable and terminate the ends, then test the cable to ensure operation.
2. Connect the Category cable to the desired HDBaseT output of the matrix switcher.
3. Connect the Category cable to the B-500-RX-230-IR Receiver or the HDBaseT device in use. Connect to an
optional 12V DC, 2A power supply (B-PS-12VDC-2A).
4. Connect an HDMI cable (2 meters or shorter is recommended) between the HDMI OUT port on the receiver
and the desired HDMI input on the display.
5. Installation is now complete. Test all connected inputs and outputs together to ensure reliable operation.
Note: For IR Passthrough integration, see section 6.17. IR Passthrough Installation and Setup, page 12.
6.13. Matrix Control Connections
All drivers, associated software and extra documentation is available under the Support tab on the
B-500-MTRX-230-8x16 / B-500-MTRX-230-16x16 product page.
6.14. IR Control
The B-500-MTRX-230 can be controlled by IR flasher from the front panel receiver or by attaching a mono cable
from the control system flasher output to the "System IR In" port on the back of the matrix switcher. For the most
reliable control, use the System IR In port.
The matrix switcher can also be controlled by commands received on IR Receiver inputs from
connected B-500-RX-230-IR HDBaseT Receivers. (See Section 6.27 IR Pass-Through from Rooms to Sources on
page 16 for an application example of this feature.)
Note: System IR control, front panel IR Receiver and Matrix control from Room can be disabled when not in
use by using the Configuration Utility. See the Configuration Utility manual section, "Other Settings" for more
information.
White/Orange
Pin 5
Orange
Pin 6
White/Green
Pin 7
Blue
Pin 8
FIGURE 3: RJ45 Pinout Configuration
Matrix IR
Control Input
FIGURE 4: System IR
White/Blue
Green
White/Brown
Brown
11
Advertisement
Table of Contents
