Table of Contents
Advertisement
8.2. IR Front Panel IR Enable
Default Setting:
This setting controls the operation of the front panel IR receiver built into the B-500-MTRX-230. This should be
disabled if using the SYSTEM IR IN port to control the matrix switcher via IR, or if the matrix switcher is missing or
receiving extra commands during use (stray IR interfering with the port).
8.3. Matrix Control from Room Enable
Default Setting:
The Matrix Control from Room Enable option allows Matrix Control IR commands to be sent from the room as if a
source were being controlled. Turn this option off if the matrix switcher is being controlled by any other method
than in-room IR.
Note: To use Matrix Control from Room, it is recommended to program a universal remote control with discrete
commands for matrix control to keep in each zone, rather than using the included IR remote or commands learned
from it. Go to the Support Tab of the B-500-MTRX-230 product page to see and download the available IR codes
and drivers for IR remote programming.
8.4. Front Panel Power Button Active
Default Setting:
The Front Panel Power Button can be disabled if desired. Disable the button when the matrix switcher is
programmed to be on at all times or in jobs where turning off the matrix from the switcher can cause issues with
control.
9. FIRMWARE UPDATE
Binary may occasionally release new firmware for the B-500-MTRX-230 to address new standards and technology.
It will never be necessary to perform an update to an existing, correctly functioning system, but during installation
or service, it is recommended to check the installed version to be sure it is the newest available.
For full update instructions, see the section titled, Firmware Update in the Configuration Utility manual. New
firmware, the Configuration Utility, and the Configuration Utility manual are available for download on the Support
Tab of the B-500-MTRX-230 product page.
Yes
Yes
Yes
21
Advertisement
Table of Contents
