Table of Contents
Advertisement
4. RECOMMENDED FOR INSTALLATION
•
Phillips Screwdriver (for rack ear attachment)
•
Up to 8 sources (16 if using the B-500-MTRX-230-16X16)
•
Up to 16 displays (32 if using both HDBaseT and HDMI outputs, see Section 6.11 Page 10)
•
Binary High Speed HDMI Cables to connect sources to B-500-MTRX-230 HDMI inputs
•
Binary HDMI cables or B-500-RX-230-IR units and Cat 5e/6 cable installed between matrix switcher location
and displays (See section 7.6.3.1, page 12 for HDBaseT wiring recommendations)
•
RJ45 connectors and termination tools (If using B-500-RX-230-IR)
•
Control System or programmable IR remote to control operation of B-500-MTRX-230
•
Windows PC with Configuration Utility installed and RS232 adapter
•
Configuration Utility Manual
5. DEVICE LAYOUT
A
FIGURE 1: B-500-MTRX-230-16x16 Switcher Layout (Front View)
5.1. Front Panel of the B-500-MTRX-230-16x16 Switcher
A. Power On/Off Switch
Toggle Power from On to Stand-by. Can be disabled from Configuration Utility software.
B. Source Status LEDs
Indicates that the selected source is on and transmitting an HDMI signal.
C. Output Display
Displays the last output selected.
D. IR Receiver Window
IR receiver for Matrix to capture commands sent by IR remote.
E. Input Display
Displays the last input selected.
B
C
D
E
5
B-500-MTRX-230-16x16
Advertisement
Table of Contents
