Table of Contents
Advertisement
7. INSTALLATION & SETUP
7.1. Basic Installation Diagram
Complete the basic installation section to set up the matrix switcher for media distribution before completing any other
setup. Use this diagram for reference during basic installation of the matrix switcher, sources, displays and wiring.
7.2. COM Port Settings
The COM port on the PC should be set to 9600 Baud, 1 Stop Bit, No Parity.
Select the COM port on the computer that is connected to the B-120-HDMATRIX from the list of available COM
ports.
If the connected COM port does not appear in the list, refer to the PC's "Device Manager" to verify that COM
ports have been installed and have the right communication settings. Find the Device Manager by searching from
the Start menu search bar, or go to Control Panel > Devices and Printers > right-mouse-click and select "Device
Manager. "
7.3. Initializing Communication
Select the "Connect" button to initiate communication between the B-120-HDMATRIX and the computer.
Once connected:
•
Button name will change to "Disconnect"
•
Status box will change to "Connected" and turn green.
If this does not occur after a few moments, perform these steps:
1. Verify that the correct COM port is selected;
2. Verify communication settings on the PCs COM port;
3. Verify that the cable has the correct PIN configuration and that it is functioning correctly.
If communication cannot be established after performing these steps, please contact SnapAV tech support.
7.4. Stopping Communication
Click the "Disconnect" button to stop communication between the B-120-HDMATRIX and the computer.
6
Advertisement
Table of Contents
