Table of Contents
Advertisement
Connector Type- RJ45
•
Use a high quality RJ45 connector that matches or exceeds the standard of the cable in use. Shielded
connectors must be used with shielded cables, and must maintain continuity of the shield to both connectors
to protect from interference.
•
Snap AV highly discourages the use of EZ style, open end RJ45's with HDMI extenders.
•
Always terminate RJ45 connectors in the HDBaseT signal path to the 568B termination standard as required
by HDBaseT standards.
6.6.3.2. Installation Instructions
1. Install the Category cable and terminate the ends, then test the cable to ensure operation.
2. Connect the Category cable to the desired HDBaseT output of the matrix switcher.
3. Connect the Category cable to the B-520-RX-230-IR Receiver or the HDBaseT device in use. The Power
over Cable (PoC) feature enables the receiver to be powered via a compatible HDBaseT transmitter, or by
connecting to an optional 12V DC, 2A power supply (B-PS-12VDC-2A).
4. Connect an HDMI cable (2 meters or shorter is recommended) between the HDMI OUT port on the receiver
and the desired HDMI input on the display.
5. Installation is now complete. Test all connected inputs and outputs together to ensure reliable operation.
Note: For IR Passthrough integration, see section 7.8. IR Passthrough Installation and Setup, page 12.
6.7. Matrix Control Connections
All drivers, associated software and extra documentation is available under the Support tab on the
B-520-MTRX-230-8x8 / B-520-MTRX-230-6x4+2 product page at www.SnapAV.com
6.7.1. Matrix Control Connections
The matrix switcher will also process commands received on IR Receiver inputs from B-520-RX-230-IR in zones
connected via HDBaseT. (See Section 7.10.2. IR Passthrough from Rooms to Sources on page 15 for an application
example of this feature.)
Note: System IR control and the front panel IR receiver can be disabled when not in use by using the Configuration
Utility. See the Configuration Utility Manual section, Other Settings for more information.
TIA/EIA Standard 568B (Gold Pins Facing Up)
Pin 1
White/Orange
Pin 2
Orange
Pin 3
White/Green
Pin 4
Blue
FIGURE 7: RJ45 Pinout Configuration
Matrix IR
Control Input
FIGURE 8: System IR
Pin 5
White/Blue
Pin 6
Green
Pin 7
White/Brown
Pin 8
Brown
IR IN
ALL IR OUT
13
Advertisement
Table of Contents
