Table of Contents
Advertisement
5.2. Rear Panel of the B-500-MTRX-230-8x8 Switcher
A
B C
D
15
13
16
14
LINK
LINK
12V DC 16A
INPUT
LINK
LINK
K
L
M
N
A. Banana Jack
Service grounding jack provided for safety. See section 13 for replacing input/output cards.
Note: Phillips screws for service located above and below replaceable corresponding input/output card.
B. Ethernet Port
RJ45 port for connecting an Ethernet Cat5e/6 cable for IP control of the B-500-MTRX-230.
C. System All IR Out
3.5mm mono mini port, repeats all IR commands from all connected HDBaseT outputs (from IR Receiver port
of B-500-RX-230-IR).
D. System IR In
3.5mm mono mini IR input port for matrix control.
E. HDBaseT Outputs 1 through 16 (RJ45)
Connect 568B terminated Cat5e/6 HDBaseT cable routed to a B-500-RX-230-IR to feed HDMI signal to
display. Output simultaneously displays the same source as the HDMI output of the same number. Odd
numbered outputs are at the top and even numbered outputs are at the bottom.
F.
HDMI Outputs 1 through 16
Connect HDMI cables to route to displays. Output simultaneously displays the same source as the HDBaseT
output of the same number. Odd numbered outputs are at the top and even numbered outputs are at the bottom.
G. Output Number Legend
Printed diagram to indicate output numbering.
H. HDMI Inputs 1 through 8 (or 16)
Connect HDMI cables from sources to the matrix switcher for distribution. Odd numbered outputs are at the
top and even numbered outputs are at the bottom.
I.
IR Output to Source 1 through 8 (or 16)
Blue 3.5mm mono mini ports are used to connect IR flashers for controlling sources. These ports may be set to
route commands only from the IR output corresponding to the HDBaseT output number (IR zone routing), or
directly to the source selected on an HDBaseT output (IR source routing). Odd numbered outputs are at the top
and even numbered outputs are at the bottom. See Section 8.1. IR Source Routing on page 20 for routing setup.
J.
IR Input to Room
Green 3.5mm mono mini ports are used to route IR commands to the B-500-RX-230-IR IR Flasher port
connected to each respective output. Use these connections to control displays or other equipment from the
matrix location. Odd numbered outputs are at the top and even numbered outputs are at the bottom. Use a
phillips head screwdriver to service a replaceable input or output card.
K. Power Jack
Dual polarized, 12V DC 16A power connections.
L. USB Port
Reserved for future use.
E
11
9
7
5
3
12
10
8
6
4
LINK
LINK
LINK
LINK
LINK
LINK
LINK
LINK
LINK
LINK
FIGURE 2: B-500-MTRX-230-16x16 Switcher Layout (Rear View)
F
G
H
1
1
O
UTPUTS
2
2
LINK
LINK
O
6
I
3
5
7
9
11
13
4
6
8
10
12
14
J
15
16
IR OUTPUT
TO SOURCE
IR INPUT
TO ROOM
IR INPUT
TO ROOM
IR OUTPUT
TO SOURCE
Advertisement
Table of Contents
