Table of Contents
Advertisement
6.18. Matrix Switcher IR Connections
The ports indicated in the diagram are described in detail below. Guides for standard applications are included on
the following pages for reference during setup.
A
B
15
13
16
14
LINK
LINK
12V DC 16A
INPUT
LINK
LINK
A. System All IR Out
This port repeats any command sent from the IR receiver ports on B-500-RX-230-IR HDBaseT receivers
connected to any HDBaseT output.
B. System IR In (3.5mm mono)
IR input port for matrix switcher IR control.
C. System Input Legend
Printed diagram to indicate input and IR connection numbering.
D. IR Output to Source
The IR output from each connected HDBaseT receiver such as the B-500-RX-230-IR is transmitted to the IR
Output to Source ports. Commands can be routed to the source selected or passed from the like-numbered
HDBaseT port.
E. IR Input to Room
Use 3.5mm mini-mono cables to connect IR outputs on a control system to these ports to send commands to
displays or equipment located at the B-500-RX-230-IR HDBaseT receiver location. The number corresponds
to the output zone number, so IR Input to Room port 1 will send signals to HDBaseT Output 1.
6.19. Matrix Switcher IR Port Configuration
All IR connection ports on the B-500-MTRX-230-8x16 / B-500-MTRX-230-16x16 are 3.5mm mono and use this
pinout configuration.
Note: Consult with the manufacturer of any attached IR equipment to confirm their pinout matches before use.
11
9
7
5
3
12
10
8
6
4
LINK
LINK
LINK
LINK
LINK
LINK
LINK
LINK
LINK
LINK
FIGURE 6: IR Connections
GND (Sleeve)
IR Signal (Tip)
FIGURE 11: IR Port Configuration
C
D
1
1
3
O
UTPUTS
2
2
4
LINK
LINK
13
E
5
7
9
11
13
6
8
10
12
14
15
16
IR OUTPUT
TO SOURCE
IR INPUT
TO ROOM
IR INPUT
TO ROOM
IR OUTPUT
TO SOURCE
Advertisement
Table of Contents
