Sending Faxes > Basic transmission procedure
Using redial
Redial is a function allowing you to dial the last entered number once again.
Use this when the receiving system does not respond when you have tried to send a fax. When you want to send the fax
to the same receiving system, select [Address Recall/Pause], and you can call the receiving system you dialed on the
destination list.
1
2
3
Select [Line Off].
When communication is disconnected, transmission stops.
NOTE
To cancel direct transmission, delayed transmission, or polling transmission, refer to the
section for that function.
To cancel direct transmission, refer to the following:
Cancelling Direct Transmission (page 3-19)
To cancel a delayed transmission or send a fax by immediate transmission, refer to the following:
Cancelling and Sending Delayed Transmissions (Queued) (page 3-22)
To cancel polling transmission, refer to the following:
Polling Communication (page 5-15)
[FAX] key > [Address Recall/Pause] key
The previously dialed destination is called.
Press the [Start] key.
The transmission will start.
NOTE
Recall information is canceled in the following conditions.
•
When you turn the power off
•
When you send a next fax (new recall information is registered)
•
When you log out
3-7