Rudder Trim Tab Actuator Assembly; Elevator Trim Tab Actuator Disassembly And Assembly; Aileron Trim Tab Actuator Disassembly - Beechcraft TRAVEL AIR 95 Shop Manual

8
7 1
6
L Snap Ring
2
Nut As embly
7. Bearing
3.
Bearing
8
Bushing
4. Actuator
Screw
9
Check Nut
5. Shoulder
Pin
or Rivet and Spacer
10
Adjusting Bushing
6. Actuator Rod End I l.
Rivet
Figure
5-13. Rudder or
Elevator
Trim Tab Actuator
RUDDER TRIM TAB ACTUATOR ASSEMBLY ELEVATOR TRIM TAB ACTUATOR DISASSEMBLY
(Figure
5-13)
AND ASSEMBLY
(Figure 5-13)
NOTE
Except
for
a slight
difference in outward
appearance the
Lubricate
all moving parts
with
MIL-G-23827.
elevator
trim
tab actuator is the same as the rudder trim tab
actuator.
To disassemble and assemble the elevator
trim tab
actuator refer
to RUDDER TRIM
TAB ACTUATOR
a.
Screw
actuator screw (4) into nut (2).
DISASSEMBLY
and RUDDER TRIM TAB ACTUATOR
ASSEMBLY.
b. Install bearing (3) on nut (2).
AILERON TRIM
TAB ACTUATOR DISASSEMBLY
c. Install bushing (8) and bearing
(7) on screw (4), and
(Figure 5-14)
install
this assembly into the housing.
d.
Install snap ring (1) into the housing. NOTE
e. Install
adjusting
bushing (10) and check nut (9).
If
there is
more than
.025
inch
end play
measured from the screw (8) to the housing (6),
f. Check
the end play between the actuator screw (4) and the acutator
is
not within
tolerance.
If the end
the actuator
housing.
The end play must not exceed 0.005 play can not
be
reduced to
.025
or less
with the
inch. The nut (2) must
be free to rotate and provide smooth adjusting bushing
the nut or screw or
both
may
operation through its
full travel.
need replaced.
NOTE a.
Remove
the snap ring (10)
from
the actuator
housing
and pull
the
nut assembly (5) out of
the housing.
Readjusting
adjusting
bushing (10) and check
nut (9) may reduce
the
endplay.
The nut must
b.
Remove the actuator screw
(8)
from the nut assembly.
remain
free
to rotate and provide smooth
operation through its
full
travel.
c.
Remove the
actuator rod end (11) from the screw. The
bearing
(4) and
the bushing (9)
can now
be
removed
from
the
screw.
g.
Install
rod
end (6) on screw (4) with spacer and rivet (5)
[later
actuators use a shoulder pin, nut and
washer]
and rivet
d. Remove the check
nut (2) and screw out the adjusting
(I1).
bushing (3)
with a spanner wrench.
C3
5-19