Upper Spar Access Panels; Removing And Installing The Landing Gear - Beechcraft TRAVEL AIR 95 Shop Manual

u
- -
°
o
95-31-69
Upper Spar Access
Panels
Figure 4-1F
c.
Detach
the electrical
wiring
from the
right
hand
adjustments
by
not disturbing the rod
end fittings,
etc.
flap
shaft.
When removing
or installing the gear, observe the following
d.
Disconnect
the
flap
shafts
from the door. precautions:
e. Disconnect
the motor electrical wiring (except
ground
wire)
at
the
quick
disconnects,
f. Remove
the
four flap
motor
attaching bolts and
Be careful
not to
bend
the skin at the wheel well edge when
the ground wire secured to one
of
the
bolts and remove the
removing
the
main strut assemblies.
flap
motor.
g.
Reinstall
the
flap
motor
by
reversing the above When reinstalling the
landing
gear,
lubricate
all fitfings with
removal
procedure.
grease,
Specification MIL-G-7711.
Torque the nuts on the
main gear hinge bolts 250
to
800 inch-pounds.
There
is
no
REMOVING AND INSTALLING THE LANDING specified torque for
the nose gear attaching
bolts. Operate
GEAR the gear to check for
proper
rigging
of
the
uplock and
doors. If
no
change in the actuating linkage has been made,
Removal
of the landing gear
is
a
comparatively
simple no rigging
adjustment should be
necessary.
Consult Section
operation,
if
care
is
taken
to preserve
the
original III for
rigging
instructions.
C4
4-7