Lucent Technologies DT3 Telephone Manual page 31

Setting a Ringer Step
Setting the Ringer Timeout
Automatic External Call Connection
Free Flow - Alias:
- Force feed.
INDeX 8.1 - DT 3/4/5 Telephone Guide
If a call rings unanswered, the phone can increase the volume
on each ring until it reaches its maximum. You can select
several sizes of increase step. This feature is call Persuasive
Ringing.
To set the ringer volume step size:
1. Press PROGRAM and then RINGER.
2. Enter the phone's passcode (see page 34) .
3. Press STEPS. The display shows the current setting;
LARGE STEP, SMALL STEP or NO STEP (no increase).
4. To select another step size, press CHANGE.
5. Press PROGRAM to finish.
The ringer timeout controls several actions:
– Callback:
How long a callback rings you before cancelling.
– Group hunting:
How long calls to a group of which your phone is a member,
ring your phone before trying the next member.
– Divert on no answer:
How long calls ring at your phone before the system uses
Divert on No Answer if set.
To set the ringer timeout:
1. Press PROGRAM and then RINGER.
2. Enter the phone's passcode (see page 34) .
3. Press TIMEOUT. The display shows the current setting.
4. Press CANCEL and enter the new timeout in seconds. The
normal value of 10 seconds is equal to 3 rings.
5. Press PROGRAM to finish.
The System Manager can set DT5 phones with ACD operation
into free flow mode. In this mode, the system connects external
calls automatically after just a single tone (but not transferred
external calls). After you end the call, the system waits 3
seconds before connecting any following call.
Ringer Controls – Page 31
38DHB0002UKAL - Issue 1 (08/99)