HP 205 G1 Maintenance & Service Manual page 113

All-in-one business pc
Table of Contents

Advertisement

Table 10-1
Numeric Codes and Text Messages (continued)
Control panel message
510-Flash Screen Image Corrupted
511-CPU, CPUA, or CPUB Fan not Detected
512-Chassis, Rear Chassis, or Front Chassis Fan
not Detected
660-Display cache is detected unreliable
1151-Serial Port A Address Conflict Detected
1152-Serial Port B Address Conflict Detected
1155-Serial Port Address Conflict Detected
1720-SMART Hard Drive Detects Imminent
Failure
1796-SATA Cabling Error
1797-SATA Drivelock is not supported in RAID
mode.
Description
Flash Screen image has errors.
CPU fan is not connected or may have
malfunctioned.
Fan is not connected or may have
malfunctioned.
Integrated graphics controller display cache is
not working properly and will be disabled.
Both external and internal serial ports are
assigned to COM1.
Both external and internal serial ports are
assigned to COM2.
Both external and internal serial ports are
assigned to same IRQ.
Hard drive is about to fail. (Some hard drives
have a hard drive firmware patch that will fix an
erroneous error message.)
One or more SATA devices are improperly
attached. For optimal performance, the SATA 0
and SATA 1 connectors must be used before
SATA 2.
Drivelock is enabled on one or more SATA hard
drives, and they cannot be accessed while the
system is configured for RAID mode.
Recommended action
3.
Replace the keyboard.
4.
Replace the system board.
Reflash the system ROM with the latest BIOS
image.
1.
Reseat CPU fan.
2.
Reseat fan cable.
3.
Replace CPU fan.
1.
Reseat fan.
2.
Reseat fan cable.
3.
Replace fan.
Replace system board if minimal graphics
degrading is an issue.
1.
Clear CMOS (See Appendix B,
Security and Resetting CMOS
on page
111.)
2.
Reconfigure card resources and/or run
Computer Setup or Windows utilities.
1.
Clear CMOS (See Appendix B,
Security and Resetting CMOS
on page
111.)
2.
Reconfigure card resources and/or run
Computer Setup or Windows utilities.
1.
Clear CMOS (See Appendix B,
Security and Resetting CMOS
on page
111.)
2.
Reconfigure card resources and/or run
Computer Setup or Windows utilities.
1.
Determine if hard drive is giving correct
error message. Run the Drive Protection
System test using F2 Diagnostics.
2.
Apply hard drive firmware patch
if applicable. (Available at
http://www.hp.com/support.)
3.
Back up contents and replace hard drive.
Ensure SATA connectors are used in ascending
order. For one device, use SATA 0. For two
devices, use SATA 0 and SATA 1. For three
devices, use SATA 0, SATA 1, and SATA 2.
Either remove the Drivelocked SATA device or
disable the Drivelock feature. To disable the
Drivelock feature, enter Computer Setup,
change Storage > Storage Options > SATA
Emulation to IDE, and select File > Save
Changes and Exit. Reenter Computer Setup and
select Security > Drivelock Security. For each
listed Drivelock-capable SATA device, ensure
POST Numeric Codes and Text Messages 105
Password
Password
Password

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

205 g2Hp 18

Table of Contents