HP 205 G1 Maintenance & Service Manual page 112

Table 10-1 Numeric Codes and Text Messages (continued)
Control panel message
163-Time & Date Not Set
164-MemorySize Error
164-MemorySize Error
201-Memory Error
213-Incompatible Memory Module in Memory
Socket(s) X, X, ...
214-SODIMM Configuration Warning
219-ECC Memory Module Detected ECC Modules
not supported on this Platform
301-Keyboard Error
303-Keyboard Controller Error
304-Keyboard or System Unit Error
104 Chapter 10 POST Error Messages
Description
CMOS jumper may not be properly installed.
Memory amount has changed since the last
boot (memory added or removed).
Memory configuration incorrect.
RAM failure.
A memory module in memory socket identified
in the error message is missing critical SPD
information, or is incompatible with the chipset.
Populated SODIMM Configuration is not
optimized.
Recently added memory module(s) support ECC
memory error correction.
Keyboard failure.
I/O board keyboard controller.
Keyboard failure.
Recommended action
contact an authorized dealer or reseller for RTC
battery replacement.
Check for proper placement of the CMOS jumper
if applicable.
Press the F1 key to save the memory changes.
1. Run Computer Setup or Windows utilities.
2. Make sure the memory module(s) are
installed properly.
3. If third-party memory has been added,
test using HP-only memory.
4. Verify proper memory module type.
1. Ensure memory modules are correctly
installed.
2. Verify proper memory module type.
3. Remove and replace the identified faulty
memory module(s).
4. If the error persists after replacing
memory modules, replace the system
board.
1. Verify proper memory module type.
2. Try another memory socket.
3. Replace SODIMM with a module
conforming to the SPD standard.
Populate the SODIMMs so that each channel has
the same amount of memory.
1. If additional memory was recently added,
remove it to see if the problem remains.
2. Check product documentation for
memory support information.
1. Reconnect keyboard with computer
turned off.
2. Check connector for bent or missing pins.
3. Ensure that none of the keys are
depressed.
4. Replace keyboard.
1. Reconnect keyboard with computer
turned off.
2. Replace the system board.
1. Reconnect the keyboard with computer
turned off.
2. Ensure that none of the keys are
depressed.