HP 205 G1 Maintenance & Service Manual page 116

Table 10-1 Numeric Codes and Text Messages (continued)
Control panel message
2231-ME error during MEBx execution
2232-AMT error during MEBx execution
2233-HECI error during MEBx execution
2239-ME image lock failure
2240-ME image unlock failure
Invalid Electronic Serial Number
Network Server Mode Active and No Keyboard
Attached
Parity Check 2
108 Chapter 10 POST Error Messages
Description
handles transference of information between
the system BIOS and ME firmware.
Error occurred during MEBx execution which
fails into "ME" grouping.
Error occurred during MEBx execution which
fails into "AMT" grouping.
Error occurred during MEBx execution which
fails into "MEI or HECI" grouping.
Special system configurations with reduced ME
firmware image require BIOS control of ME
firmware upgrading. A failure has occurred
after the ME firmware update process in which
the BIOS could not relock the ME firmware
region.
Special system configurations with reduced ME
firmware image require BIOS control of ME
firmware upgrading. A failure has occurred prior
to the ME firmware update process in which the
BIOS could not unlock the ME firmware region.
Electronic serial number is missing.
Keyboard failure while Network Server Mode
enabled.
Parity RAM failure.
Recommended action
3. If the error still persists, replace the
system board.
1. Reboot the computer.
2. If the error persists, update to the latest
BIOS version and ME firmware version.
3. If the error still persists, replace the
system board.
1. Reboot the computer.
2. If the error persists, update to the latest
BIOS version and ME firmware version.
3. If the error still persists, replace the
system board.
1. Reboot the computer.
2. If the error persists, update to the latest
BIOS version and ME firmware version.
3. If the error still persists, replace the
system board.
1. Reboot the computer.
2. If the error persists, update to the latest
BIOS version and ME firmware version.
3. If the error still persists, replace the
system board.
1. Reboot the computer.
2. If the error persists, update to the latest
BIOS version and ME firmware version.
3. If the error still persists, replace the
system board.
Enter the correct serial number in Computer
Setup.
1. Reconnect keyboard with computer
turned off.
2. Check connector for bent or missing pins.
3. Ensure that none of the keys are
depressed.
4. Replace keyboard.
Run Computer Setup and Diagnostic utilities.