Advertisement
Certain options may be grayed out depending on the particular MicroConverter you may have.
Run Automatically after Download
7.
Click on the Configuration button. Tick the box for 'Run automatically after download' as
shown in the configuration window above. Click on OK. Enter serial download mode as in
step 3.1.2. Download as in step 3.2.4. The program starts running automatically after
download as can be seen by the flashing LED.
NOTE:
Use of the PC COM Port:
Only one application may use the PC serial port at any one time.
The WSD only uses the PC COM serial port when
• Resetting the device
• Downloading to the device
• Sending the Run command to the device
Therefore,
the
Debugger/WASP/Hyperterminal or any other application that uses the PC COM serial port.
However if another application, that uses the PC serial port, is open then the WSD will not be
able to communicate with the MicroConverter until the PC serial port is released by
disconnecting/closing the other application.
REV 1.3
WSD
does
not
ADuC8XX GetStarted Guide
have
to
be
closed
-- 8 --
(3.0) The Windows Serial Downloader
before
launching
www.analog.com/microconverter
the
Advertisement
Need help?
Do you have a question about the ADUC812 and is the answer not in the manual?
Questions and answers