Set Up The Lens - Christie D4K3560 Setup Manual

2. Carefully slide the shroud sideways and forward away from the lens mount and lens.
3. Place the shroud covers on a clean surface to prevent scratches.

Set up the lens

Warning! Failure to comply with the following could result in death or serious injury.
• Keep fingers and other body parts away from the moving parts in the projector. Motors and fans
may start without warning.
• Tie back long hair, remove jewelry and loose clothing before manually adjusting the projector.
Notice. Failure to comply with the following may result in property damage.
The lens seals the projection head, preventing contaminants from entering the main electronics area.
Do not operate the projector without a lens installed. Use a lens plug when installing or transporting
the projector.
1. Remove the projector shroud.
2. Make sure the lens locking lever is in the up position.
3. If attached, remove the rear lens cap from the lens.
4. Slide the lens into the lens mount, aligning all connections.
Always install the lens with UP label in the top position to achieve consistent boresight
i
alignment each time the lens is replaced.
5. Secure the lens with the lens locking lever (down position).
6. Calibrate the lens motors.
D4K3560 Setup Guide
020-101161-05 Rev. 1 (06-2015)
1
2
Installation and Setup
25