Table of Contents
Advertisement
Cabling the BEETLE /XL
The BEETLE /XL is specified for a horizontal mounting. If you install the
system vertically, observe the following:
Stand the device with the ventilator side facing upward.
To ensure proper ventilation, keep the following minimum spaces
clear above and below the device:
Below: 60 mm
Above: 100 mm
A closed area made of nonflammable material (e.g. concrete or
metal) must be located under the vertically mounted BEETLE /XL.
Cabling the BEETLE /XL
To install the devices, proceed as follows (in this order):
Make sure that the power switch on the front of the housing is set to
"off" (i.e. visibly protruding). To do this, you may have to open the
slide cover first (see the illustration on page GB - 15).
GB - 12
100 mm
Cabling the BEETLE /XL
The individual POS system
30
60 mm
Advertisement
Table of Contents
