Auto Start - Fuji Xerox DocuColor 1256 GA Series Manual

I Auto start
You can enable the Auto Start feature by pressing the Start button while waiting for the machine to
warm up after the power is switched on.
G Enabling Auto Start
To use the Auto Start feature, load the document, select the desired features and press the Start button.
The message "Please wait ... The job will start automatically." will be displayed. Once the machine is
ready, the document will automatically be scanned and the desired copies will be output.
G If you have set the machine ready tone in Tools Mode, you will hear the tone when the machine has warmed up and is ready
to accept copy jobs. You can then proceed to set an auto start job after the tone. See "6.3 Setting the Feature Defaults" on
how to set the tones and change their volumes.
Auto Start screen:
G Cancelling Auto Start
To cancel an Auto Start job, firstly, select Stop on the screen before the document is scanned.
Alternatively, press the Stop button on the control panel. Then press the C button and the Auto Start job
will be cancelled.
I Breaker switch
G The power will automatically be cut
off once the breaker switch detects a
power leakage. Do not use the
machine in such a case.
Safety Notes
When an A4 document is placed on the document glass and three
copies of the document are to be made at 100% magnification.
The breaker switch is
usually pushed to the
top, as shown in the
diagram on the right.
If the machine will not be
used for a long time or
when moving the
machine, push the
switch down.
1.2 Switching On/Off the Power
1
9