General Information
Selecting a Riding Mode –
when Riding the Motorcycle
Warning
The selection of riding modes while
the motorcycle is in motion requires
the rider to allow the motorcycle to
coast
(motorcycle
moving,
running, throttle closed, clutch lever
pulled in and no brakes applied) for a
brief period of time.
Riding
mode
selection
motorcycle is in motion should only be
attempted:
•
At low speed
•
In traffic free areas
•
On straight and level roads or
surfaces
•
In
good
road
and
conditions
•
Where it is safe to allow the
motorcycle to briefly coast.
Riding
mode
selection
motorcycle is in motion MUST NOT be
attempted:
•
At high speeds
•
While riding in traffic
•
During cornering or on winding
roads or surfaces
•
On
steeply
inclined
surfaces
•
In poor road/weather conditions
•
Where it is unsafe to allow the
motorcycle to coast.
Failure to observe this important
warning will lead to loss of motorcycle
control and an accident.
50
Note:
•
It is not possible to select the RIDER
Mode while the motorcycle is in
motion if ABS and/or TTC are set to
Off when setting the RIDER Mode
options (see page 52).
Press and release the MODE button on
the instrument housing until the desired
riding mode is flashing in the display.
engine
while
the
weather
while
the
1.
MODE button
2. Selected riding mode (flashing)
3. Current (active) riding mode
Note:
•
The
automatically activated when the
following conditions are met:
roads
or
Within 30 seconds of pressing the MODE
button the rider must carry out the
following simultaneously:
•
Close the throttle
•
Pull the clutch in
•
Ensure that the brakes are not
engaged (allow the motorcycle to
'coast').
2
1
selected
riding
mode
3
is