Maintenance and Adjustment
Caution
Do not cover the headlight or lens
with any item likely to obstruct air
flow to, or prevent heat escaping from,
the headlight lens.
Covering the headlight lens during
operation with items of clothing,
luggage,
adhesive
tape,
intended to alter or adjust the
headlight
beam
or
non
headlight lens covers will cause the
headlight lens to overheat and distort,
causing irreparable damage to the
headlight assembly.
Damage caused by overheating is not
considered a manufacturing defect
and
will
not
be
covered
warranty.
If the headlight must be covered
during use – such as taping of the
headlight lens required during closed-
course conditions – the headlight
must be disconnected.
150
Headlight Adjustment
Each headlight can be adjusted by
means
of
adjustment screws located on the rear
of each headlight. In addition, the
headlight is equipped with an easily
accessible adjuster to allow the vertical
adjustment to be corrected when the
motorcycle is fully loaded.
devices
genuine
3
under
2
cgim
1.
Horizontal (LEFT - RIGHT)
adjustment screw
2. Vertical (UP - DOWN) adjustment
screw
3. Headlight adjuster lever for loaded
conditions
Switch the headlight dipped beam on.
Turn
the
adjustment screw on the headlight
clockwise
to
counterclockwise to lower the beam.
Turn the horizontal (LEFT - RIGHT)
adjustment screw clockwise to move the
beam to the right or counterclockwise to
move the beam to the left.
Switch the headlights off when the beam
settings are satisfactory.
vertical
and
horizontal
1
vertical
(UP
-
DOWN)
raise
the
beam
or