Selecting A Riding Mode - With The Motorcycle Stationary; Selecting A Riding Mode - When Riding The Motorcycle - Triumph T120 Owner's Manual

General information
Bonneville T120
ROAD Standard throttle response.
RAIN Reduced throttle response when
compared to the ROAD setting, for
wet or slippery conditions.
Riding modes can be selected when the
motorcycle is stationary or moving.
Selecting a Riding Mode – with the
Motorcycle Stationary
Press and release the MODE button on
the instrument housing until the desired
riding mode is flashing in the display.
Note:
• The selected
automatically activated one second
after the MODE button is pressed, if
the following conditions are met:
With the Engine Off
• The ignition is switched ON
• The engine stop switch is in the
RUN position.
With the Engine Running
• Neutral gear is selected or the
clutch is pulled in.
36
riding mode is
Selecting a Riding Mode – when
Riding the Motorcycle
Warning
The selection of riding modes while the
motorcycle is in motion requires the
rider to allow the motorcycle to coast
(motorcycle moving, engine running,
throttle closed, clutch lever pulled in
and no brakes applied) for a brief
period of time.
Riding mode selection
motorcycle is in motion should only be
attempted:
At low speed
In traffic free areas
On straight and level roads or surfaces
In good road and weather conditions
Where it is safe
motorcycle to briefly coast.
Riding mode selection
motorcycle is in motion MUST NOT be
attempted:
At high speeds
Whilst riding in traffic
During cornering or on winding roads
or surfaces
On steeply inclined roads or surfaces
In poor road/weather conditions
Where it is unsafe to allow the
motorcycle to coast.
Failure to observe
warning will lead to loss of motorcycle
control and an accident.
while the
to allow the
while the
this important