Triumph Tiger XRX Owner's Handbook Manual page 51

Once the MAP, ABS and TTC settings
have changed, the selected riding mode
will be displayed and the previous mode
will no longer be visible.
1
1. Selected riding mode
Resume riding as normal.
Note:
• If any one of the systems (MAP, ABS
or TTC) fails to change to the
settings specified by the selected
riding mode, both the previous and
the selected riding mode icons will
flash.
1
1. Incomplete mode change (flashing)
General Information
The flashing of two riding mode icons
together indicates that MAP, ABS or TTC
settings specified by the selected riding
mode have not been correctly selected.
In this case the MIL, ABS or TTC warning
light(s) may be illuminated depending on
the current state of each system.
In the event of an incomplete riding
mode change:
• Safely bring the motorcycle to a stop
• Select neutral gear
• Turn the ignition OFF and then back
ON again
• Select the desired riding mode
• Restart the engine and continue
riding.
Warning
Do not stop the engine using the
ignition switch or engine stop switch
while the motorcycle is moving. Always
bring the motorcycle to a stop safely
and engage neutral gear prior to
stopping the engine. Stopping the
engine by turning off the ignition or
engine stop switch
motorcycle is moving can lock the rear
wheel causing loss of motorcycle
control and an accident.
while the
51