Selecting A Riding Mode - With The Motorcycle Stationary; Selecting A Riding Mode - When Riding The Motorcycle - Triumph Bonneville Bobber 2016 Owner's Handbook Manual

General Information
Selecting a Riding Mode – with the
Motorcycle Stationary
Press and release the MODE button on
the instrument housing until the desired
riding mode is flashing in the display.
The selected
automatically activated
after the MODE button is pressed, if the
following conditions are met:
With the Engine Off
• The ignition is switched ON.
• The engine stop switch is in the
RUN position.
With the Engine Running
• The transmission is in neutral or
the clutch is pulled in.
30
riding mode
one second
Selecting a Riding Mode – when
Riding the Motorcycle
is
The selection of riding modes while the
motorcycle is in motion requires the
rider to allow the motorcycle to coast
(motorcycle moving, engine running,
throttle closed, clutch lever pulled in
and no brakes applied) for a brief
period of time.
Riding mode
motorcycle is in motion should only be
attempted:
At low speed
In traffic free areas
On straight and level roads or surfaces
In good road and weather conditions
Where it is safe to allow the motorcycle
to briefly coast.
Riding mode
motorcycle is in motion MUST NOT be
attempted:
At high speeds
While riding in traffic
During cornering or on winding roads
or surfaces
On steeply inclined roads or surfaces
In poor road/weather conditions
Where it is unsafe to allow the
motorcycle to coast.
Failure to
warning will lead to loss of motorcycle
control and an accident.
Warning
selection while
selection while
observe this important
the
the