Disposal Of Used Engine Oil And Oil Filters; Oil Specification And Grade - Triumph Tiger XRX Owner's Handbook Manual

Maintenance and Adjustment
Fill the engine with a 10W/40 or 10W/50
semi or fully synthetic
engine oil that meets specification
API SH (or higher) and JASO MA, such as
Castrol Power 1 Racing 4T 10W-40 (fully
synthetic).
Start the engine and allow it to idle for a
minimum of 30 seconds.
Caution
Raising the engine speed above idle
before the oil reaches all parts of the
engine can cause engine damage or
seizure. Only raise engine speed after
running the engine for 30 seconds to
allow the oil to circulate fully.
Caution
If the engine oil pressure is too low,
the low oil pressure warning light will
illuminate. If this light stays on when
the engine is running, stop the engine
immediately and investigate
cause. Running the engine with low oil
pressure will cause engine damage.
Ensure that the low oil pressure warning
light remains off and the oil Pr message
is not visible in the instrument display
screen.
Stop the engine and recheck the oil level.
Adjust if necessary.
Disposal of Used Engine Oil and Oil
Filters
To protect the environment, do not pour
oil on the ground, down sewers or
drains, or into groundwater sources. Do
not place used oil filters in with general
waste. If in doubt, contact your local
authority.
118

Oil Specification and Grade

motorcycle
Triumph high performance fuel injected
engines are designed to use 10W/40 or
10W/50 semi
motorcycle
specification API SH (or higher) and
JASO MA,
Racing 4T
engine oil, sold as Castrol Power RS
Racing 4T 10W-40 (fully synthetic) in
some countries.
Triumph recommends the fully synthetic
10W/40 motorcycle engine oil for most
conditions. The oil viscosity may need to
be changed
ambient temperatures in you riding area.
Refer to the chart below for the correct
oil viscosity (10W/40 of 10W/50) to be
used in your riding area.
Ambient Temperature (ºC)
-20 -10
the
-4 14
Ambient Temperature (ºF)
Oil Viscosity Temperature Range
Do not add any chemical additives to the
engine oil. The engine oil also lubricates
the clutch and any additives could cause
the clutch to slip.
Do not use mineral, vegetable, non-
detergent oil, castor based oils or any oil
not conforming
specification. The use of these oils may
cause instant, severe engine damage.
or fully synthetic
engine oil that meets
such as Castrol Power 1
10W-40 (fully synthetic)
to accommodate
0 10 20 30 40 (°C)
SAE 10W/50
SAE 10W/40
32 50 68 86 104 (°F)
to the required
the