Escape Sequences - AMX MST-1001 Configuration Manual

^RAF, ^RMF - Embedded Codes
Parameter
dynamo
Notification setting

Escape Sequences

The ^RAF and ^RMF commands support the replacement of any special escape sequences in the filename (specified by the %F
embedded code) with the corresponding data obtained from the system as outlined in the table below:
Escape Sequences
Sequence
$DV
$SY
$IP
$HN
$MC
$ID
$PX
$PY
$ST
$AC
$AP
$CC
$CP
$LC
$LP
$BX
$BY
$BN
For instance, http://www.amx.com/img.asp?device=$DV
would become
http://www.amx.com/img.asp?device=10001.
Modero S Series Touch Panels - Configuration & Programming Manual
Embedded Code
'%D'
'%C<on,off,once>'
Panel Information
Device Number
System Number
IP Address
Host Name
Mac Address
Neuron ID (Only supported on panels that use ICSNet; ignored on all other panels)
X resolution of current panel mode/file
Y resolution of current panel mode/file
Current state
Address code
Address port
Channel code
Channel port
Level code
Level port
X Resolution of Current button
Y Resolution of Current button
Name of Button
Description
Enable/disable Fast Dynamo.
Panel will attempt to accelerate this resource in hardware.
Indicates whether a notification is required when a Dynamic Image is loaded/
refreshed.
The string following the %C can be:
1. on - notifications are sent whenever the named dynamic image resource is
loaded/refreshed.
2. off - notifications are not sent (default).
3. once - notifications are sent one time whenever the named dynamic image
resource is loaded/refreshed. Notifications are not sent on subsequent loads/
refreshes.
If the %C code is not sent as part of a ^RAF command, the notifications are set to off.
If the %C code is not sent as part of a ^RMF command, the notifications are not
changed from the current setting.
Programming
73