Bpp; Brd; Bsf; Bsm - AMX MST-1001 Configuration Manual

Button Commands (Cont.)

^BPP

^BRD

?BRD

^BSF

^BSM

Modero S Series Touch Panels - Configuration & Programming Manual
Set or clear the protected page flip flag of a button. Sets the button to protected page flip flag 1 (sets it to password 1).
• Syntax:
"'^BPP-<vt addr range>,<protected page flip flag value>'"
• Variables:
variable text address range = 1 - 4000.
protected page flip flag value range = 0 - 4 (0 clears the flag).
• Example:
SEND_COMMAND Panel,"'^BPP-500,1'"
Set the border of a button state/states. Only if the specified border is not the same as the current border. The border names
are available through the TPDesign4 border-name drop-down list. Refer to theTPD4 Border Styles by Name table on
page 92.
• Syntax:
"'^BRD-<vt addr range>,<button states range>,<border name>'"
• Variables:
variable text address range = 1 - 4000.
button states range = 1 - 256 for multi-state buttons (0 = All states, for General buttons 1 = Off state and 2 = On state).
border name = Refer to the Border Styles and Programming Numbers table on page 91.
• Example:
SEND_COMMAND Panel,"'^BRD-500.504&510.515,1&2,Quad Line'"
Sets the border by name (Quad Line) to those buttons with the variable text range of 500-504 & 510-515.
Get the current border name.
• Syntax:
"'?BRD-<vt addr range>,<button states range>'"
• Variables:
variable text address range = 1 - 4000.
button states range = 1 - 256 for multi-state buttons (0 = All states, for General buttons 1 = Off state and 2 = On state).
custom event type 1014:
Flag - Zero
Value1 - Button state number
Value2 - Actual length of string
Value3 - Zero
Text - String that represents border name
Text length - Border name length
• Example:
SEND COMMAND Panel,"'?BRD-529,1'"
Gets the button 'OFF state' border information.
The result sent to the Master would be:
ButtonGet Id = 529 Type = 1014
Flag = 0
VALUE1 = 1
VALUE2 = 22
VALUE3 = 0
TEXT = Double Bevel Raised -L
TEXT LENGTH = 22
Set the focus to the text area.
Note: Select one button at a time (single variable text address). Do not assign a variable text address range to set focus to
multiple buttons. Only one variable text address can be in focus at a time.
• Syntax:
"'^BSF-<vt addr range>,<selection value>'"
• Variables:
variable text address range = 1 - 4000.
selection value = Unselect = 0 and select = 1.
• Example:
SEND_COMMAND Panel,"'^BSF-500,1'"
Sets the focus to the text area of the button.
Submit text for text area buttons. This command causes the text areas to send their text as strings to the NetLinx Master.
• Syntax:
"'^BSM-<vt addr range>'"
• Variables:
variable text address range = 1 - 4000.
• Example:
SEND_COMMAND Panel,"'^BSM-500'"
Submits the text of the text area button.
Programming
58