Table of Contents
Advertisement
Projecting
Adjusting the image manually
Check the connections of the peripheral devices and
connection of the power cord (
Æ
on the power (
page 31) to start the projector.
Selecting the image
J
Select an input signal.
The image selected with the <COMPUTER 1>,
<COMPUTER 2>, <HDMI>, <VIDEO>, <S-VIDEO>,
or <NETWORK> button is projected (
Attention
Images may not be projected properly depending on the
z
connected device and DVD, video tape, etc. to be played.
Select a system format that is suitable for the input signal
in [Component] or [RGB] in the [Input] menu (
Check the aspect ratio of the screen and the image and
z
select the optimum aspect ratio under the [Screen] menu
Æ
(
page 52).
Adjusting the state of the image
J
1 )
Adjust the projection angle
For details, see "Adjusting front adjustable feet"
z
(
page 27).
Æ
2 )
Adjust the zoom and the focus
Turn [Zoom lever] and [Focus ring] to adjust the
image.
Focus ring
Note
If you adjust the focus, you may need to adjust the size
z
of the image by moving the zoom lever again.
If keystone distortion occurs, see "KEYSTONE"
z
Æ
(
page 53).
34
- ENGLISH
Æ
page 29) and switch
Æ
page 38).
Æ
page 43).
Zoom Lever
Adjusting the image
automatically
Easy setting function makes the semi-automatically
adjustment possible, so that to get the optimal image.
Auto setup function including these following functions
(
Æ
page 56-57).
Switching the input signal
Input search
automatically.
The image projected from the
Auto PC adj.
computer automatically is optimal.
The color of the bar assists the focus
Focus assist
adjustment.
Detect and correct the image
automatically to fit the frame. If
Screen fit
you can not detect the frame of
the screen, Keystone (standard)
executes automatically.
The color values will change
automatically to reach the optimal
Colorboard
white balance according to the color
of screen.
Auto setup
J
When all of the above mentioned functions are set to
[On], the adjustment orders are as follows.
1 )
Project an image.
2 )
Adjust the zoom ring so that the image is
larger than the screen frame.
3 )
Press the <AUTO SET> button on the remote
control or the <AUTO SETUP> button on the
control panel during projection.
[Please wait ...] appears, Input search function
starts to work and select an input signal.
If the input signal is an computer (analog)
signal, Auto PC adj. function starts to work
and get an optimal image.
Next, a test pattern for [Focus assist] appears
on the screen and the focus assist bar appears
in the center bottom of the screen.
4 )
Rotate the focus ring until the bar changes to
blue and the image reaches to the maximum
level.
Advertisement
Table of Contents
