Restoring Networking Parameters To Their Initial State; Accessing The Embedded Web Server - 3Com VCX v7111 Installation Manual

At the prompt type "conf" and press enter; the configuration command shell is activated.
3
To check the current network parameters, at the prompt, type "GCP IP" and press enter;
4
the current network settings are displayed.
Change the network settings by typing: "SCP IP [ip_address] [subnet_mask]
5
[default_gateway]" (e.g., "SCP IP 10.13.77.7 255.255.0.0 10.13.0.1"); the new settings
take effect on-the-fly. Connectivity is active at the new IP address.
Note: This command requires you to enter all three network parameters (separated by
spaces).
To save the configuration, at the prompt, type "SAR" and press enter; the VCX V7111
6
restarts with the new network settings.

Restoring Networking Parameters to their Initial State

You can use the 'Reset' button to restore the VCX V7111 networking parameters to their
factory default values (described in Table 10 on page 27) and to reset the username and
password.
Note that this process also restores the VCX V7111 parameters to their factory settings,
there you must your previously backed up ini file or the default ini file (received with the
software kit) to set them to their correct values.
To restore networking parameters to their initial state, follow these steps:
Disconnect the VCX from the power and network cables.
1
Reconnect the power cable; the gateway is powered up. After approximately 45 seconds
2
the Ready LED turns to green and the Control LED blinks for about 3 seconds.
While the Control LED is blinking, press shortly on the reset button (located on the left
3
side of the front panel; the gateway resets a second time and is restored with factory
default parameters (username: "Admin"' password: "Admin").
Reconnect the network cable.
4
Load your previously backed-up ini file, or the default ini file (received with the software
5
kit). To load the ini file via the Embedded Web Server, see Chapter 5: Restoring and
Backing Up the VCX V7111 Configuration on page 43.

Accessing the Embedded Web Server

To access the Embedded Web Server, follow these steps:
Open a standard Web-browsing application such as Microsoft™ Internet Explorer™
1
(version 6.0 and higher) or Netscape™ Navigator™ (version 7.0 and higher).
In the URL field, specify the IP address of the VCX V7111 (e.g., http://10.1.10.10 for the
2
VCX V7111 FXS); the Embedded Web Server's 'Enter Network Password' screen
appears (Figure 16 on page 32).
3Com VCX V7111 Fast Track Installation Guide 31