Localtalk Setup - Netopia R2020 User Reference Manual

EtherTalk Phase II port is visible to other AppleTalk nodes. The default zone is also where new AppleTalk
nodes will appear. If you do not set a default zone, the first zone you create will be the default zone.
You can also set the range of EtherTalk Phase II network numbers. Select Net Low and enter the lower limit
of the network number range. Select Net High and enter the upper limit of the range.
Select the Seeding pop-up menu and choose the seeding method for the Netopia R2020 to use (see
"Routers and seeding" on page
You have finished configuring EtherTalk Phase II.

LocalTalk Setup

Note: For instructions on making the physical connections for LocalTalk, see
network" on page 4-5.
Select LocalTalk Setup in the AppleTalk Setup screen and press Return to the LocalTalk Routing Setup screen.
LocalTalk Enabled:
LocalTalk Zone Name:
LocalTalk Net Number:
Seeding...
Use this screen to set up the LocalTalk Port Routing attributes.
If you are using LocalTalk with the Netopia R2020, select LocalTalk Enabled and make sure LocalTalk is
set to On, which is the default.
Note: Since the LocalTalk connector attaches to the Auxiliary port on the router, that port will no longer be
available for a third external modem.
Select LocalTalk Zone Name and enter a new or existing zone name.
Note: Your LocalTalk network may already have a zone and network number in place. For the Netopia
R2020's LocalTalk port to be part of your LocalTalk network, it must have a network number and zone
name that matches the values in use on the LocalTalk network.
If another router is already present on the LocalTalk network that you will be connecting to the Netopia
R2020, use the zone name and network number used by that router for that LocalTalk network. Otherwise,
your LocalTalk network may experience routing conflicts.
12-3).
LocalTalk Setup
"Connecting to a LocalTalk
On
Unnamed
33126
Soft-Seeding
AppleTalk Setup 12-7