Printronix P5000 Maintenance Manual page 355

28. Apply the double-sided tape to one end of the control panel standoff.
Remove the paper backing and hold the standoff inside the cabinet while
you insert the upper mounting screw and washer through the hole in the
frame. Use the screw as a guide to align the standoff with the hole, then
press the standoff against the inside wall and push the upper screw in as
far as it will go. Now maneuver the control panel into position and install
the upper mounting screw finger tight in the control panel. (Figure 82.)
29. Inspect the distance between the control panel lower bracket and the
inner panel of the cabinet.
a. If the control panel lower bracket is flush with the cabinet inner panel,
b. If there is a gap between the control panel lower bracket and the
30. Install the lower mounting screw and washer. Tighten the upper mounting
screw. (Figure 82.)
Stacker
Control
Panel
Control
Panel Lower
Bracket
Lower Mounting Screw
Cabinet Inner Panel
Figure 82. Installing the Stacker Control Panel
proceed to step 30.
cabinet inner panel, do the following:
1) Peel the backing off the spacer adhesive. (Figure 82.)
2) Align the spacer with the holes in the lower bracket and inner
panel. (Figure 82.)
3) Press the spacer adhesive against the inner panel. (Figure 82.)
Standoff
Spacer
Adhesive
Backing
Washer
Double-Sided Tape
Upper Mounting
Screw
Washer
355