Printronix P5000 Maintenance Manual page 191

Notch
1
Latch
3
Latch
Memory Requirements for Emulation Options
Emulation IGP
LP+
Options LP+
Flash 4 MB 4 MB
DRAM 4 MB 4 MB
CT Installed No No
Controller Board
Flash:
80-pin SIMM
J11 = Bank 0 (must always
be filled)
J10 = Bank 1
Reserved for upgrades
If 1 Flash SIMM, use Bank 0.
2
If 2 Flash SIMMs, use both
banks but put pre-programmed
SIMMs in J11.
IMPORTANT:
No matter what combination of SIMMs is used,
J11 and J16 must always be filled. The controller
board does not support EDO RAM.
PGL
VGL
ANSI ANSI
ANSI
LP+ LP+
LP+
4 MB 4 MB 4 MB
4 MB 4 MB 4 MB
No No No
Figure 26. Memory and Security Modules
Memory And Security Modules
Bank 1
Bank 0
Bank 1
Bank 0
Notched End
DRAM:
72-pin SIMM
J16 = Bank 0 (must always
be filled)
J15 = Bank 1
Reserved for upgrades
If 1 DRAM SIMM, use Bank 0.
If 2 DRAM SIMMs, use both
banks. (It does not matter which
SIMM goes into which bank.)
CT CT IPDS
CT
PGL VGL CT
LP+
LP+ LP+ LP+
4 MB 4 MB 4 MB 4 MB
4 MB 4 MB 4 MB 4 MB
Yes Yes Yes Yes
Security Module
IPDS IPDS
CT CT
PGL VGL
LP+ LP+
4 MB 4 MB
4 MB 4 MB
Yes Yes
191