Chapter
5
Section I: Replacement Procedures
STAT (Status) Indicator In Run And Auto Reset Modes
Run Mode is the normal operating state of this interface. Auto Reset mode is
entered when the watchdog timer is triggered and the print server resets itself.
In either mode, the STAT LED flashes at a varying rate, depending on
whether the unit IP address is configured:
NET (Network) Indicator
The NET LED displays the status of the network link:
DIP Switches
On the back of the 10/100Base-T interface inside the printer, there are two
DIP switches labeled 1 and 2. The functions of the DIP switches are
described in Table 5.
194
STAT
Rate
OFF
Flashes ON
once per second
OFF
Flashes ON 2
times per second
ON
Flashes OFF
once per second
ON
Flashes OFF
twice per second
NET
Rate
ON
Constantly
ON
Flashes OFF 1/3
second
OFF
Constantly
Indication
Normal Mode, IP address configured
IP address not configured
Download (MOS)
Error
Indication
Indicates link integrity
Flashes off 1/3 second every time a
data packet is transmitted
Network connection has been severed