Printronix P5000 Maintenance Manual page 187

Gently press down on the mounting
base and hold the hammer spring in
position as you install the screws.
Use new screws from the kit.
Torque the screws to 14 inch-
pounds (1.58 Newton-meters).
Torque the inner screws first.
Figure 25. Hammer Spring Assembly, Installation
Hammer Spring Assembly
NOTE: The hammer spring assembly
shown here is for a P5015 printer.
Although hammer spring assemblies
vary in appearance and number of
mounting screws, removal and
installation are the same for all models.
New Hammer
Spring Assembly
187