Printronix P5000 Maintenance Manual page 197

Installation
1. Position the paper feed motor assembly on the right side plate and install
the motor mount bolts and nuts finger tight. (See page 244, items 10 and
23.)
2. Connect the paper feed motor cable connector to connector P107, then
connect P107 to J107 on the controller board. (See page 172.)
3. Roll the paper feed timing belt onto the splined shaft pulley and the motor
pulley
4. Using the straight end of a force gauge, apply 15 pounds (66.7 N) of
pressure to the paper feed motor. Use the splined shaft to steady the
gauge.
5. Reduce pressure to 12 pounds (53.4 N) and torque the 5/16 inch motor
mount screws to 18 ± 2 inch-pounds (2.03 ± 0.23 N•m).
6. Snap the timing belt cover into the slots in the side plate.
7. Cabinet Models: Install the barrier shield and tighten the four screws.
(See page 230, items 3, 4, and 9.)
Pedestal Models: Install the barrier shield and paper guide and tighten the
four screws. (See page 232, items 3, 4, and 5.)
8. Cabinet Models: Install the paper path (page 199).
Pedestal Models: Install the top cover assembly (page 179).
9. Return the printer to normal operation (page 133).
Paper Feed Motor
197