Philips HDRW720 Service Manual page 69

Example DS:> 1229
122900: 6D7920626F61726400020300010101020101000020080000
Test OK @
Nucleus Name DS_SYS_AudioLoopThroughStart
Nucleus Number 1230
Description Description: The audio input is routed from the an input to all outputs. Input is set with
the routing nucleus 1113. All outputs are enabled.
User Input None.
Example DS:> 1230
123000:
Test OK @
Nucleus Name DS_SYS_AudioLoopThroughStop
Nucleus Number 1231
Description Stop routing the audio input to all the outputs
User Input -
Example DS:> 1231
123100:
Test OK @
Nucleus Name DS_SYS_SettingsHwIdSet
Nucleus Number 1232
Description Double check whether stored HW-string equals actual HW as far as we can
automatically detect this. An automatic and a manual mode is supported.
User Input -
-
encountered error
Example DS:> 1233
123300:
Test OK @
DS:> 1233 manual
123300:
Test OK @
DS:> 1233
123301:Hardware ID mismatch: in HW-Diversity string:99, actual in FLASH:0
Error @
DS:> 1233 manual
Hardware ID mismatch! in HW-Diversity string:99, actual in FLASH:0
Enter the correct HW ID of the digital board.
> 0
The HW-diversity string has been modified by you. Settings:
Board name:
Hardware ID:
Codec IC:
Video Input Processor IC:
Progressive Scan Deinterlacer IC: None
Progressive Scan Denc IC:
I-Link physical layer circuit IC: PDI1394P25
I-Link link layer circuit IC:
Audio clock:
Bit engine connector:
IDE connector 1:
IDE connector 2:
PCI connector:
RAM size
ROM size (NOR FLASH bank 1)
ROM size (NOR FLASH bank 2)
ROM size (NAND FLASH)
Is it OK to program this inthe new HW-diversity string? ([y]es/[n]o):y
Diversity HW-string programmed successfully.
123300:
Test OK @
DS:>
Diagnostic Software
'manual' or 'MANUAL' to enter manual mode
default is automatic mode where the nucleus stops upon and reports the first
DIAG
0
PNX7100_MF3
SAA7118
ADV7196
PDI1394P40
Clock scheme 1
available
available
not available
not available
32MByte
Not available
HDRW720/0x, DVDR725H/0x
8MByte
Not available
5. EN 69