Philips HDRW720 Service Manual page 62

EN 62 5. HDRW720/0x, DVDR725H/0x
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
Nucleus Name
Nucleus Number
Description
User Input
Example
Nucleus Name
Nucleus Number
Description
User Input
Example
Nucleus Name
Nucleus Number
Description
User Input
Example
Input Audio Signal is routed from FRONT Cinch In to Digital Board.(This is same as path ID
01)
Input Signal is from Rear Cinch In1 and it will be routed to Digital Board..
No routing.
No routing.
No routing.
No Routing.
No routing.
No Routing.
No Routing.
No Routing.
Input Signal is from Digital Board and it will be routed to the digital board.
No routing.
Input is Audio Signal from TUNER and it will be routed to Digital Board.
Input signal is AUDIO from dvio board and will be routed to Digital Board.
No routing.
No routing.
No routing.
Input signal is from REAR AUDIO IN 2 and will be routed to the digital board.
Input signal is from REAR AUDIO IN 1 and will be routed to the digital board.
Input signal is from REAR AUDIO IN 1 and will be routed to the digital board.
The Audio signal received from the Digital board will be outputted on Modulator channel 3.
The Audio signal received from the Digital board will be outputted on Modulator channel 4.
DS_ANAB_SelectTunerChannel
1114
Set the tuner to receive a valid audio and video signal
<Frequency*16> <video standard id>Tuner frequency: to tune the tuner to e.g. 216
MHz, this parameter must be 3456. (Since 216*16 = 3456. This is to avoid the decimal
points to the parameter list.)Video standard id: The table below shows which video
standards are possible
Video standard id
163248648096112
DS:> 1114 3456 16
111400:
Test OK @
DS_ANAB_IICWriteRead
1115
Perform an IIC write and read action on the analogue board
Writing:
[<W>|<w>] [I2C address] [number of data bytes to write]
with
<data[0]...data[n]> Max 16 data bytes (n < 16).
Reading:
[<R>|<r>] [I2C address] [number of data bytes to read]
Max 16 data bytes (n < 16).
DS:> 1115 w 0x94 2 0x06 0x02
111500:
Test OK @
DS_ANAB_ClockAdjust
1116
Set the clock to the value passed through in the YYYY MM DD HH MM SS format
<YYYY> <MM> <DD> <HH> <MM> <SS>
DS:> 1116 2002 11 11 11 11 11
111600:
Test OK @
Diagnostic Software
Europe
PAL_BG
PAL_I
PAL_DK
SEC_L
SEC_LS
SEC_BG
SEC_DK
NAFTA
NTSC
Invalid
Invalid
Invalid
Invalid
Invalid
Invalid