Philips HDRW720 Service Manual page 60

EN 60 5. HDRW720/0x, DVDR725H/0x
Nucleus Name
Nucleus Number
Description
User Input
Example
Nucleus Name
Nucleus Number
Description
User Input
Example
Nucleus Name
Nucleus Number
Description
User Input
Example
Video routing paths (Europe)
Path ID
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
Video routing paths (NAFTA)
Path ID
0
1
DS_ANAB_SoftwareVersionDiagnosticsGet
1110
Get the software version of the diagnostic software of the analogue board
None
DS:> 1110
111000: Diagnostics application version : 11.00.13
Test OK @
DS_ANAB_ChecksumProgram
1111
Check the checksum of the several partitions by recalculating and comparing partition
checksums
None
DS:> 1111
BootCode checksum is: 0xBABE6240, which is correct
Diagnostics checksum is : 0xBABEBEAD, which is correct
Download checksum is: 0xBABEA6B7, which is correct
Application checksum is : 0xBABEB277, which is correct
111100:
Test OK @
DS_ANAB_VideoRouting
1112
Perform the routing of the video paths on the analogue board
The user has to input the correct parameter for the routing (see table 'video routing'
below).
DS:> 1112
00111200:
Test OK @
Description
Input signal is VIDEO(CVBS) from digital board and will be re-routed back to the digital
board.
Input signal is from FRONT VIDEO(CVBS) IN and will be routed to the digital board.
No Routing.
Input signal is from FRONT S-VIDEO(Y/C) and will be routed to the digital board.
No Routing.
Input signal is CVBS from SCART1 and will be routed to the digital board.
Input signal is CVBS from SCART2 and will be routed to the digital board.
Input Signal is CVBS from Digital Board and it will be routed to Scart1 and Scart2.
Input signal is VIDEO(CVBS) from ANTENNA IN and will be routed to SCART2.
Input signal is VIDEO(CVBS) from SCART1 and will be routed to SCART2.
Input signal is VIDEO(CVBS) from SCART2 and will be routed to SCART1.
Signal path is routed Fast Blank from Scart2 pin16 and will be routed SCART1 pin16
Input Signal is YC from Digital Board and it will be routed to SCART1.
No Routing.
Input Signal is CVBS from TUNER and it will be routed to Digital .
No Routing.
Input Signal is routed from digital board YC to REAR S-VIDEO(YC) OUT
Signal path is routed from digital board RGB to RGB SCART1 and from digital board
CVBS to digital board CVBS.
No Routing.
Input RGB Signal is routed from Digital Board to SCART1(RGB),Input CVBS Signal
from Digital Board to Digital Board and Fast Blanking Signal from SCART2 to
SCART1.
Input Y/C Signal from Digital Board is routed to Rear Y/C Connector and Input Y/C
Signal from Front Y/C connector is routed to Digital Board.
Description
No Routing.
Input signal is from FRONT VIDEO(CVBS) IN and will be routed to the digital board.This
routing is same as the above path id.
Diagnostic Software