Philips DVDR725H Software Upgrade Instructions
Philips dvdr725h: software guide
Hide thumbs
Also See for DVDR725H:
- Specifications (3 pages) ,
- Technical specifications (2 pages) ,
- Service manual (211 pages)
Related Manuals for Philips DVDR725H
Summary of Contents for Philips DVDR725H
- Page 1 Upgrade disc for HDRW720 & DVDR725H PHILIPS...
-
Page 2: Important Information
Important information The upgrade software available on the Philips internet applies to: HDRW720/00, HDRW720/02, HDRW720/05, HDRW720/69, HDRW720/17, DVDR725H/00, DVDR725H/02, DVDR725H/05. For the software (CF2.6 and newer version) a new instruction manual is available also. The new instruction manual does not apply to older software versions. -
Page 3: Table Of Contents
Content How to make an upgrade disc Upgrade procedure To find out the software version of your set Trouble shooting Software history... -
Page 4: How To Make An Upgrade Disc
How to make an upgrade disc You need the following items: A Personal Computer with internet connection A drive that can write on CD-R/CD-RW discs A blank (new) CD-R disc, no CD-RW as this may cause problems CD writing application A Zip archive utility Download the upgrade software Zip file from internet on a local hard disk drive of your PC. -
Page 5: Upgrade Procedure
Upgrade procedure Press OPEN/CLOSE to open the tray. Insert the upgrade CD-ROM disc, label side up. Press OPEN/CLOSE to close the tray. Ø First ‘READING’ appears on the display, followed by ‘DOWNLOAD ’. The upgrade procedure can take up to 45 minutes in total. Ø... -
Page 6: To Find Out The Software Version Of Your Set
To find out the software version of your set The below procedure is not needed for upgrading but could help in case you need to call the helpdesk. It may be useful to write down the system version information of your DVD recorder If there is any disc in the recorder, remove it and close the tray. -
Page 7: Troubleshooting
The upgrade disc may be damaged or not properly recorded. - If it is a CD-R you created, make a new disc, following the guidelines closely. - If it is a CD-ROM you received from Philips contact your Philips Customer Care Center. -
Page 8: Software History
Software history (1) CF3.2 - Readability of DVD+R Dual Layer discs has been improved. - Readability of commercial discs has been improved. CF3.1 - Bug fixed in Service and Diagnostic mode. Not relevant for the customer. CF3.0 new features - EPG programme information available (when broadcastet) within Guide or Browser - The following Harddisc navigation speeds were added: 64x, 128x and 256x - Exit CAM mode also via tuner button possible - Playback of dual layer DVD+R discs possible... - Page 9 Software history (2) CF2.6 Problem: Pin 8 of SCART I connector will switch after a timer recording finished that was started from standby. This will result in your TV to switch the external input for a few seconds when the timer recording is finished. Solution: Corrected pin 8 behaviour (Europe only) Problem:...
- Page 10 Software history (3) CF1.6 Problem: Some channels in the guide editor change from ON to OFF. Then these channels do not appear in the grid anymore. User have to switch them ON again. Solution: Major improvement in CNI scanning. (EU only) Others: - Implemented EPG version 1.19 to control SKY boxes to switch them ON and OFF (EU)
- Page 12 http://www.philips.com/dvdrecorder...